1. INSTALLATION
1-8
How to attach the plug M-P-5
Lay the coaxial cable and attach an M-type plug to the cable as follows.
1. Remove the sheath by 30 mm.
2. Bare 23 mm of the center conductor. Trim braided shield by 5 mm and tin.
3. Slide coupling ring onto cable.
4. Screw the plug assembly on the cable.
5. Solder plug assembly to braided shield through solder holes. Solder contact
sleeve to conductor.
6. Screw coupling ring into plug assembly.
Waterproofing connector
Wrap connector with vulcanizing tape and
then vinyl tape. Bind the tape end with a
cable-tie.
1.7 AC-DC Power Supply (option)
When selecting a mounting location for the unit, keep the following in mind:
• Keep the unit away from areas subject to water splash.
• Locate the unit away from exhaust pipes and vents.
• The mounting location should be well ventilated.
• Mount the unit where shock and vibration are minimal.
• A magnetic compass will be affected if the unit is placed too close to it. Observe the
compass safe distances noted in the safety instructions to prevent disturbance to
the magnetic compass.
Fix the unit with four self-tapping screws (4×16) to a desktop or the deck. It is not nec-
essary to open the cover.
Sheath
30 mm
5 mm
2 mm
Conductor
Insulator
Braided shield
Plug assembly
Contact sleeve
Cut conductor
here.
Solder both
sides of hole.
Coupling ring
To Next Page
Loading...
Need help?
General
