2-1
2. SHIP INFORMATION INPUT
You must set the ship static information after the installation of the equipment. The FA-
70 is set up from the PC or external display (TZTL12F*/15F* or TZT12F/16F/19F).
When setting from the PC, install the USB driver and PC software (see sections 2.1
and 2.2). When setting from the external display, open the home screen, and then se-
lect [Settings] - [Initial Setup] - [NETWORK SENSOR SETUP] - [FA-70] in order to dis-
play the menus.
*: The software version 07.01 or later is required.
2.1 How to Install the Driver
The CD-ROM for PC software and USB driver is supplied as standard.
Note 1: Install the driver with administration rights.
Note 2: In the case of Microsoft
®
Windows
®
10, the “Driver” file is already installed. If
you need to re-install this file, install this file in [Device Manager].
Note 3: “Microsoft.NET Framework 4(×86 or ×64)” is installed at the time of the AIS
Setting Tool installation.
The following instructions are for Windows
®
7.
1. Turn the FA-70 on.
2. Connect the USB cable between the FA-70 and the PC.
3. Set the supplied CD-ROM in the CD drive.
4. Click the [Start] button and then click [Control Panel].
5. Click [Device Manager].
6. Enter the administrator password and then click [Yes].
7. Double-click [Other devices] – [VIRTUAL COM PORT] in order.
8. Click the [General] tab and then click [Update Driver…].
9. Click [Browse my computer for driver software].
10. Select the [USBDriverForWindows7] folder in the CD-ROM.
11. Click [Install this driver software anyway] to install the driver. After the installation,
[FURUNO AIS (COMxx)] is displayed in [Ports (COM & LPT)] of [Device Manag-
er].
12. Remove the CD-ROM from the CD drive.
To Next Page
Loading...
Need help?
General
