3.16.1 ECO mode
This function automatically turns off the loop signal in
the boundary loop, the guide wires and the charging
station when the robotic lawnmower is not mowing, i.e.
when the lawnmower is charging or is not allowed to
mow due to timer settings.
The
ECO mode
is suitable to use where there is other
wireless equipment not compatible with the robotic
lawnmower e.g.certain hearing loops or garage doors.
When
ECO mode
is activated, the indicator lamp in the
charging station flashes green.
ECO mode
means that
the robotic lawnmower can only be started in the
charging station and not out in the working area.
In
ECO mode
, it is very important to always press the
STOP button before removing the robotic lawnmower
from the charging station. It is otherwise not possible to
start the robotic lawnmower. If the lawnmower has been
removed by mistake without first pressing the STOP
button, the lawnmower must be placed back in the
charging station and the STOP button pressed. Only
then can the robotic lawnmower be started inside the
working area.
Select
RUN ECO mode
and press
OK
to activate
ECO
mode
.
Note: Always press the STOP button before removing
the robotic lawnmower from the charging station. In
ECO mode
the robotic lawnmower otherwise will not be
started inside the working area.
3.16.2 Time & Date
This function allows you to set current time and required
time format in the robotic lawnmower.
•
Set time:
Enter the correct time and press
OK
to
exit.
•
Set date:
Enter correct date and press
OK
to exit.
•
Time format:
Place the cursor at the required time
format: 12h 24h. Press
OK
to exit.
•
Date format:
Place the cursor at the required date
format:
YYYY-MM-DD (year-month-day)
MM-DD-YYYY (month-day-year)
DD-MM-YYYY (day-month-year)
Exit by pressing
OK
.
3.16.3 Language
Set language with this function.
To select language: Place the cursor at the required
language and press
OK
.
3.16.4 Country
With this function you can select in what country the
robotic lawnmower will work.
Place the cursor at the required country and press
OK
.
3.16.5 Backlight, R38Li, R40Li, R45Li, R50Li
To indicate where the robotic lawnmower is at night in
the working area, it is possible to allow the display to
remain on when the robotic lawnmower is in operation:
1. Select
Backlight
in the menu and press
OK
.
2. Select one of the following options:
•
Auto
: The display is lit for 1 minute after the
latest key press.
•
ON
: The display is lit all the time when the
robotic lawnmower operates. The display is not
lit when the robotic lawnmower is stopped due
for instance to a timer setting or possible
disruption.
3.16.6 Remote start, R38Li, R40Li, R45Li, R50Li
One important function with the guide wire is the
capacity to steer the robotic lawnmower to remote
garden areas when required. This function is very useful
in gardens where, for instance, the front and back are
joined by a narrow passage where the charging station
cannot be installed.
303 - 001 - 21.09.2017 Installation - 27
To Next Page
Loading...
