Powerboat Autopilot Operation
GHC 10 Owner’s Manual 7
The u-turn pattern turns the boat around 180° and maintains the new
heading. There are no settings to adjust for the u-turn pattern.
1. From the heading screen, select > > .
2. Select .
3. Select an option:
• Select to begin a starboard turn.
• Select to begin a port turn.
The autopilot follows the u-turn pattern, and the heading screen shows
the direction of the turn
➀
.
➀
When the u-turn is completed, the autopilot maintains the new heading.
To quickly resume a pattern after you make a heading adjustment with
the helm or the soft keys (page 3), select the center soft key twice.
The man overboard pattern turns the boat around with the intent of running
alongside the location where the man overboard pattern was initiated. There
are no settings to adjust for the man overboard pattern.
‹
The man overboard pattern is not determined by GPS and is affected by
wind, current, and speed. Be ready to adjust the throttle and take the helm to
avoid harm to a person in the water.
‹
The boat must be below planing speed when using this pattern.
1. From the Heading screen, select > >
.
2. Select .
3. Select an option:
• Select to begin a starboard turn.
• Select to begin a port turn.
To Next Page
Loading...
Need help?
General
