Reference
35
‘Alarms’ File Tab
Setting the Speed Alarm
‘Alarms’ File Tab
‘Alarms’ File Tab (top right picture)
Approaching Waypoint Alarm - Provides an alarm message once you are within a set time (choices
range from 15 seconds to five minutes) from your turn or destination waypoint. As you approach the
waypoint, a message occurs when your estimated arrival time is within the alarm time entered.
Speed Alarm - Provides an alarm message as a reminder when your speed exceeds a preset limit.
To enable/disable the speed alarm:
1. Highlight the ‘Speed Alarm’ field and press the ENTER key.
2. Select On or Off (as desired) and press the ENTER key.
3. If enabling the alarm, highlight the speed in the same field and press the ENTER key. Enter the
desired alarm speed using the ROCKER keypad (bottom right picture) and press the ENTER key.
To Next Page
Loading...
Need help?
General
