66
OPERATING
WARNING: Both the STEAM LEVER
and HOT WATER dial must be in the
CLOSED position for the machine to
enter START UP mode.
BEFORE FIRST USE
Machine Preparation
Remove and discard all labelling and
packaging materials attached to your
espresso machine. Ensure you have
removed all parts and accessories
before discarding the packaging.
Clean parts and accessories (water
tank, portafilter, filter baskets, jug) using
warm water and a gentle dish washing
liquid and rinse well.
The water filter located inside the water
tank will need to be removed before
washing the water tank.
Conditioning the Water Filter
1. Remove filter from the plastic bag
and soak in a cup of water for 5
minutes.
2. Rinse filter under cold running water.
3. Wash the stainless steel mesh in the
plastic filter compartment with cold
water.
4. Insert the filter into the filter holder.
5. Set Date Dial 2 months ahead.
6. To install filter, push down to lock into
place.
7. Slide the water tank into position
and lock into place.
We suggest changing the water filter
at least every two month. Please use
only Gastroback water filters Art.-No.:
97765.
FIRST USE
Initial Start Up
• Fill tank with water
• Check Steam Lever and Hot Water
dial is in the CLOSED position.
• Press POWER On.
• A pumping sound will be heard indi-
cating empty boilers are being filled
with water for the first time.
• Machine will reach operating tempe-
rature and go into STANDBY mode.
Flushing The Machine
When the machine has reached STAND-
BY mode, run the following 3 steps:
1. Press 2 Cup button to run water
through group head.
2. Run Hot Water for 30 seconds.
3. Activate Steam for 10 seconds.
Repeat this cycle until tank is empty.
TIP:
You can maneuver your machine
about the bench using the drop down
swivel foot located under the drip tray.
To Next Page
Loading...
Need help?
General
