Basic operating commands
Figure 2 below shows the panel keypad and Table 4 below describes the system’s
basic commands.
Figure 2: Panel touchpad
3
6
9
#
2
1
5
Options
8
Ch i m e
4
St a t u s
7
No Delay
Si l e n t
Quick Exit
Disarm
Back
*
0
Byp ass
Sel e c t
3
6
9
2
1
5
8
4
7
0
Arm
Table 4: Basic system commands
Task Command
Check system status Press Status (*)
Disarm the system Press Disarm + code
Arms doors and windows Press Arm + code
Arm doors and windows, no delay Press Arm + code + No Delay (4)
Arm motions, doors and windows Press Arm (twice) + code
Arm motions, doors and windows, no delay Press Arm (twice) + code + No Delay
Arm system silently Press Silent + Arm + code
Turn chime feature on and off (only when system
is unarmed)
Press Chime (7)
Identify open sensor, trouble conditions, and
alarms in memory
Press Status (*)
Bypass a zone Press Bypass (#) + primary code
Quick exit (for use when system is armed) Press Quick Exit (starts a two-minute timer for use
of one entry/exit door)
Police panic Press and hold both the Arm and 1 buttons until
the panel indicates the alarm
Fire panic Press and hold both the Silent and Chime (7)
buttons until the panel indicates the alarm
8 Allegro Control Panel User Manual
To Next Page
Loading...
Need help?
General
