Arming level 3
When everyone will be away from the premises, set your system to level 3 (motions,
doors, and windows) for maximum protection. In level 3 all sensors are active
including perimeter door and window sensors and interior motion detectors.
To arm to level 3 using the panel keypad:
1. Close all perimeter doors and windows.
2. Press Arm twice.
The panel displays Enter Code to ARM.
3. Enter your access code.
The panel displays EXIT TIME XX and Lock Motion Sensors, Doors
and Windows. The system sounds three short beeps.
4. Exit through a designated delay door before the delay time expires.
Note: If the quick arm feature is on, an access code is not required to arm the system
to level 3.
To arm to level 3 using a keychain touchpad:
1. Press Lock twice to go from level 1 to level 3, or once to go from level 2 to level 3.
The system sounds three short beeps.
To arm to level 3 using a wireless touchpad:
1. Press Arm Motion Sensors and enter your access code.
Allegro Control Panel User Manual 11
To Next Page
Need help?
General
