Only sensors active in the current arming level can be bypassed. Attempting to
bypass a sensor that is already bypassed activates or unbypasses the sensor.
To bypass sensors directly:
1. Close all doors and windows.
2. Arm your system to the desired level.
3. Press Bypass (#).
The panel displays Enter Code to BYPASS.
4. Enter your primary access code.
The panel displays the sensors that are active in that level and can be bypassed in
the system.
5. Scroll through the list of sensors and press Select (#) to select the sensor to
bypass.
The panel displays ZONE XX OFF and the press status icon turns on (the status
message includes the bypassed and open sensors).
Note: If a key is not pressed for five seconds, the panel exits bypass sensor mode.
The bypassed door or window can now be opened.
Indirect bypassing. Use this method if you are arming the system and would like to
bypass doors and windows that are already open.
To bypass sensors indirectly:
1. Leave open only those doors and windows that are to remain open. Close all
others.
2. Arm your system to the desired level.
The panel emits protest beeps and displays
PROTEST and ZONE XX OPEN.
3. Press Bypass (#) to immediately bypass the sensor, or allow the delay time to
expire and the sensors bypass automatically.
The system sounds arming level beeps to indicate that the system is armed and
open sensors have been successfully bypassed.
To confirm that a sensor was bypassed, press Status (*). The panel lists bypassed and
opened sensors or zones.
16 Allegro Control Panel User Manual
To Next Page
Loading...
Need help?
General
