To perform a sensor test:
1. Press the down arrow until you see
SENSOR TEST displayed.
2. Press #.
The display scrolls though untested zones and beeps to indicate successful sensor
packets.
3. Count the number of beeps and see Table 6 below for the number required.
4. Trip each sensor.
5. The panel displays TEST DONE when all sensors have been tested.
Table 6: Sensor tripping instructions
Sensor Tripping instructions Number of beeps
DTIM Initiate a sensor test. 7 to 8
Door/Window Open the secured door or window. 7 to 8
Carbon monoxide alarm Unplug the alarm. Plug it back in, wait 10 seconds, then
press the test/reset button until the unit beeps 8 times.
7 to 8
Glass guard Tap the glass 3 or 4 in, from the sensor. 7 to 8
Motion sensor Avoid the motion sensor field of view for 5 minutes, and
then enter its view.
7 to 8
Rate-of-rise heat
detector
Rub you hands together until warm, and then place one
hand on the detector for 30 seconds.
7 to 8
Shock sensor Tap the glass twice (away from the sensor). Wait at
least 30 seconds before testing again.
7 to 8
Smoke sensor Press and hold the test button until the system sounds
transmission beeps.
7 to 8
Panic button Press and hold the appropriate panic buttons for 3
seconds.
7 to 8
Keychain touchpad Press and hold the Lock and Unlock buttons
simultaneously for 3 seconds.
7 to 8
Remote handheld
touchpad
Press and hold the two emergency buttons
simultaneously for 3 seconds.
7 to 8
Hardwire loop Open the secured door or window. 1
If the panel sounds less than the required number of beeps when a zone/sensor is
tripped, this indicates wireless sensor signal strength is below acceptable limits.
Distances from the receiver and/or installation environment are most likely affecting
the sensor’s signal strength. Contact your dealer/installer if this occurs.
22 Allegro Control Panel User Manual
To Next Page
Loading...
Need help?
General
