EasyManuals Logo
Home>GE>Control Panel>Allegro

GE Allegro User Manual

GE Allegro
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
Wireless
touchpad
System doesn’t respond to commands entered from the wireless touchpad.
Check the touchpad for dead batteries and replace batteries if needed.
If problem persists, contact your dealer/installer.
Touchpad reports a trouble condition.
Check the touchpad battery for low voltage. Replace the battery if necessary.
If problem persist, contact your dealer/installer.
Wireless
sensor zone
or DTIM
System doesn’t respond (in sensor test or when armed) when sensor is tripped.
Contact your dealer/installer.
Sensor or DTIM reports a trouble condition.
Perform a sensor test. If trouble condition persists, contact your dealer/installer.
Panel tamper The touchpad reports a panel or phone module tamper.
Verify that the panel or phone module (DTIM) cover is closed.
Trouble
beeps
Panel sounds four short beeps every minute.
A trouble condition exists. Press Status. See Table 12 on page 30 to determine the
cause.
Allegro Control Panel User Manual 25

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Allegro and is the answer not in the manual?

GE Allegro Specifications

General IconGeneral
BrandGE
ModelAllegro
CategoryControl Panel
LanguageEnglish

Related product manuals