GE C30 User Manual

GE Multilin C30 Controller System G-3
APPENDIX G G.1 CHANGE NOTES
G
Table G–4: MAJOR UPDATES FOR C30 MANUAL REVISION Z1
PAGE
(Y3)
PAGE
(Z1)
CHANGE DESCRIPTION
--- --- Add Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal View
figure in chapter 3, and CPU Module Communications Wiring figure in chapter 3
--- --- Add Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
1-1 1-1 Add Added General Cautions and Warnings to section 1.1.1
1-5 1-5 Update Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
2-8 2-8 Update Updated several specifications
5-20 5-20 Add Added section 5.2.5e Routing
5-78 5-78 Update Updated Figures 5-21 and 5-22 Dual Breaker Control Scheme Logic, sheets 1 and 2
5-82 5-82 Update Updated Figure 5-23 Disconnect Switch Scheme Logic
5-124 5-124 Add Reinserted section 5.7.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
Table G–5: MAJOR UPDATES FOR C30 MANUAL REVISION Y3
PAGE
(Y2)
PAGE
(Y3)
CHANGE DESCRIPTION
-- ix Add Added battery disposal information as chapter 0
Table G–6: MAJOR UPDATES FOR C30 MANUAL REVISION Y2
PAGE
(Y1)
PAGE
(Y2)
CHANGE DESCRIPTION
All All Update Minor changes throughout document
All All Delete Deleted CPU options U and V
1-1 1-1 Update Updated Figure 1-1 Rear Nameplate
3-8 3-8 Update Updated Figure 3-10 Rear Terminal View
Table G–7: MAJOR UPDATES FOR C30 MANUAL REVISION Y1 (Sheet 1 of 2)
PAGE
(X2)
PAGE
(Y1)
CHANGE DESCRIPTION
All All Delete Deleted content pertaining to Ethernet switch
Title Title Update Changed part numbers. Updated address and contact information.
1-1 1-1 Update Updated address and contact information
2- 2- Add Added CPU options T, U, and V to order code tables
2- 2- Delete Deleted E, G, H, J, S from CPU options from order code tables. Deleted 9S, 2S, 2T from
replacement module order code tables.
3-10 3-10 Update Updated Figure 3-12 Typical Wiring Diagram
2-12 2-12 Update Updated Ethernet fiber table in section 2.2.6 Communications
3-21 3-21 Update Deleted references to COM 1 RS485 port in section 3.2.8 CPU Communication Ports. Revised
text and Figure 3-22 CPU Module Communications Wiring to include only modules T, U, V in
section 3.2.8a.
5-1 5-1 Update Updated the front panel main menu to include the CyberSentry security menu
5-11 5-11 Update Updated Communications main menu to remove the SNTP Protocol submenu
5-11 5-11 Delete Deleted references to COM 1 RS485 port in section 5.2.4b Serial Ports

GE C30 Specifications

General

Brand	GE
Model	C30
Category	Controller
Language	English