5.4.3.3 Separating the Lift Rail from the Belt Channel
Refer to “Figure 5-28 Right Upright Disassembly”.
1. If you can access the screw head through the access hole in the lift rail go to step 2. If you can not access
the screw, push the lift rail and the belt channel together and lift the belt block up past the roll pin so you
can see the screw head through the access hole in the lift rail.
2. Remove the screw that secures the lift rail and the belt channel together (this will require either a 3 or 4mm
hex key).
5.4.3.4 Replacing the Rail Drive Belt
Refer to “Figure 5-30 Replacing the Drive Belt”.
STEP 6
SCALE 1/10
SEE DETAIL E
DETAIL E
SCALE 1/2
Belt
Plastic belt block
Brass belt block
Leaf spring
Roll pin
Figure 5-30 Replacing the Drive Belt
1. Using a 5.5 mm wrench, remove the Nylok nuts that secure the springs coil to the plastic belt block. The
springs will roll back around their spools.
2. Using a 2mm hex key, remove the 2 screws that secure lower belt guard, remove the guard and run the
belt o the bottom sprocket.
3. Using a 2mm hex key, remove the 4 screws (one in each corner) that hold the halves of the plastic belt
block together.
98 6600-0343-000 104 © 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Chapter 5: Repair Procedures
To Next Page
Loading...
Need help?
General
