To Next Page

To Previous Page

80 8181

Connecting the camera and printer.

1. Make sure both the camera and printer are turned

on.

2. Connect one end of the supplied USB cable to the

USB port on your camera.

3. Connect the other end of the cable to the USB port

on the printer.

If the camera is not connected to a PictBridge

compatible printer, the following error message appears

on the LCD screen.

The above error message would also appear if the

USB mode were set incorrectly, in which case you

should disconnect the USB cable, check the USB

mode settings, ensure that the Printer is turned

on, and then try connecting the USB cable again.

Questions and Answers:

Need help?

Do you have a question about the GE J1050 and is the answer not in the manual?

GE J1050 Specifications

General

Megapixel	10.1 MP
Camera type	Compact camera
Sensor type	CCD
Image stabilizer	Yes
Digital zoom	5.7 x
Optical zoom	5 x
Focal length range	6.3 - 31.5 mm
Interface	USB 2.0/AV-OUT
Digital SLR	No
Focal length (35mm film equivalent)	35 - 175 mm
Focus adjustment	Auto
Normal focusing range	0.8 ~ ∞ m
Auto focusing (AF) modes	multi point auto focus, single auto focus
Macro focusing range (tele)	0.6 - ∞ m
Macro focusing range (wide)	0.05 - 0.8 m
Internal memory	24 MB
Compatible memory cards	sd, sdhc
Maximum memory card size	8 GB
Display diagonal	2.7 \
Display resolution (numeric)	230000 pixels
USB version	2.0
Product color	Black
Battery type	DS5370
Battery capacity	700 mAh
Number of batteries supported	1
Flash modes	auto, Flash off, Red-eye reduction
Scene modes	Backlight, beach, Children, Documents, Fireworks, Museum, Night landscape, Night portrait, Panorama, party (indoor), Portrait, Sports, Sunset, Landscape (scenery)
Maximum video resolution	640 x 480 pixels