Installation Instructions
OUTSIDE TOP EXHAUST (Vertical Duct)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Install Adapter
A4. Mount Oven
A5. Adjust Exhaust Adaptor
A6. Gonnect Ductwork
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
=_===
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to a
wall stud.
[]Remove the toggle wings flom the bolts.
[]Insert the bolts into the mounting plate
through the holes designated to go into d_Twall
and reatmch the toggle wings to :_" onto each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
+l_-_i_--Thickness
Wings
Mounting
Plate_.
BoltEnd
_ Place the mounting plate against the wall and
insert tim toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the robs on the mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be carefifl to avoid pinching fingers
between the back of the mounting plate and the wall.
_ Tighten all bolts. Pull the plate away flom the wall
to help tighten the bolts.
12
To Next Page
Loading...
Need help?
General
