Installation Instructions
RECIRCULATING (Non-Vented Ductless)
INSTALLATION OVERVIEW
C1. Attach Mounting Plate to Wall
C2. Prepare Top Gabinet
C3. Adjust Blower
C4. Mount the Oven
C5. Install Gharcoal Filter
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts. At
least one wood screw must be used to attach the
plate to a wall stud.
_ Remove the toggle wings flom the bolts.
_ Insert tim bolts into the mounting plate through
the boles designated to go into d_ywall and
reatmch the toggle wings to ¾" onto each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
+l_,_i_Thickness
M itl-oggleWings
ountmg II1,11 / Toggle II I'+t
Plate..lll_::l.._Bolt,_\11I!:i_
II,' :l<-Wall l! ,:l I
BoltEnd
_ Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the robs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflfl to avoid pinching fingers
between the back of the mounting plate and the wall.
_ Tighten all bolts. Pull the plate away flom the wall
to help tighten the bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
-275.........
• Read the instructions on the TOP GABINET
TEMPI ,ATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPI,ATE.
CAUTION: Wear safeb, goggles when drilling holes
in the cabinet bottom.
19
To Next Page
Loading...
Need help?
General
