Installation Instructions
I-_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws, a
hole large enough for tim power cord to fit through,
and a cutout large enough for tim exhaust adaptor.
• Read tim instructions on the TOP CABINET
TEMPI ,ATE.
• Tape it underneath tim top cabinet.
• Drill the holes, following tim instructions on tim
TOP CABINET TEMPI,ATE.
CAUTION: Wear safety goggles when drilling holes
in tim cabinet bottom.
ASSEMBLE AND
INSTALL ADAPTOR
Damper
g Exhaust
Adaptor
i_ BlowerPlate
__7 Backof
oven
NOTE: On some models, the exhaust adaptor and
damper assembly may aheady be assembled to the oven.
[]Place the oven in its upright position, with the top
of the unit facing tap.
NOTE: Make sure the blower fan blades are visible
and are pointing up.
_ Insert the tabs on each side of the damper into the
holes at the inside rear of the adaptor.
_ Attach the exhaust adaptor to tim blower plate with
the t_,vobronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adjttstments to assure proper
alignment with your house exhaust duct after the
oven is installed.
13
I-_ MOUNT THE OVEN
FOR EASIER INSTAI,I,ATION AND PERSONAl,
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of tim cord.
NOTE: We recommend using fillet blocks if the
cabinet flont hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting the
oven, thread power cord
through hole in bottom
of top cabinet. Keep it fight
ttnoughout Steps 1-3.
Do not pinch cord or lift
oven by pulling cord.
I,iff oven, tilt it
forward and hook
slots at back bottom
edge onto two lower
robs of mounting
plate.
\
_ Rotate flont of
oven
up against cabinet
bottom.
To Next Page
Loading...
Need help?
General
