GE JVM1540 User Manual

Installation Instructions
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood scIew Illtlst be used to attach the plate to a
wall stud.
[]Remove the toggle wings flom the bolts.
[]Insert the bolts into the mounting plate through
the holes designated to go into drDvall and reatmch
the toggle wings to :_" onto each bolt.
To use toggle bolts:
Spacingfor TogglesMore
-_l-,--!-,_ ThanWall Thickness
M .. IToggleWings
ountmg IIl'.,.li /Toggle II I.:1
Plate_lll,:.::ll.t_ Bolt II I::K
Ini: I-<-Wall In u,l I
BoltEnd
[]Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall
to i_lotlnt the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflfl to avoid pinching fingers
between the back of the mounting plate and the wall.
[]Tighten all bolts. Pull the plate away flom the wall
to help tighten the bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPI_ATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instiuctions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling boles in
the cabinet bottom.
16

GE JVM1540 Specifications

General

Brand	GE
Model	JVM1540
Category	Microwave Oven
Language	English