GE Kilsen KFP-CF Series User Manual

Kilsen KFP-CF Series Operation Manual 1
Introduction
This is the access level 1 and access level 2 operation manual for the Kilsen KFP-CF
series fire alarm control panels. Read these instructions and all related
documentation entirely before operating this product.
Product range
The KFP-CF series includes the models shown below.
Model Description
KFP-CF2 Two-zone fire alarm control panel
KFP-CF4 Four-zone fire alarm control panel with fire routing
KFP-CF8 Eight-zone fire alarm control panel with fire routing
Fire routing on the four- and eight-zone models is not available for all operating
modes. See “Sounder and fire routing delays” on page 2.
Operating modes
Supported operating modes are shown in the table below. The default operating
mode is EN 54-2.
Table 1: Operating modes
Operating mode Region
EN 54-2 (default) European Union
EN 54-2 Evacuation European Union (Spain)
EN 54-2 Scandinavia European Union (Scandinavia)
BS 5839-1 United Kingdom
NBN S21-100 Belgium
NEN 2535 The Netherlands
The choice of operating mode used depends on your location and the specific
regional requirements of your fire alarm system.
As there is no visual indication of the active operating mode, your installation or
maintenance contractor should provide full details of your configuration.

GE Kilsen KFP-CF Series Specifications

General

Brand	GE
Model	Kilsen KFP-CF Series
Category	Control Panel
Language	English