4. Press CLOSE repeatedly to exit.
Emergency icon
In an emergency, touch the Emergency icon. An Emergency screen appears (See
Emergency icon in Table 4 on page 5). You will see three icons (Panic, Police, or Fire).
Select the appropriate icon.
Note: If your system is connected to a security monitoring service, the authorities will
be notified. This option may not be enabled. Contact your dealer for details.
If you initiate an emergency alarm by mistake, you can cancel the alarm by touching
the red alarm icon (“Alarms” on page 12) and entering your code within 30 seconds
(typical time limit, contact your dealer for more information on your system
configuration).
System tests
This menu lets you run sensor and communication tests, and initiate a phone call
from the panel to Enterprise Downloader. For more information, see “Testing” on
page 31.
Programming
To enter programming mode:
Note: Programming mode can only be entered if the system is disarmed.
1. Enter the Status & Settings menu.
2. Scroll until Programming is listed, press the Enter icon.
3. Enter your master code, and then press OK.
Note: You have four seconds between number presses to enter the code or you
will be returned to the home screen.
At this point, you are in the Programming menu. At this level, the following submenus
are accessible:
• Access Codes
• Security
• Phone Numbers
• Siren Options
• System Tests
• Interactive Services (Optional. Ask your dealer for more information.)
The sections below describe the options that you can program in each of the
programming submenus.
Simo
n XTi User Manual 27
To Next Page
Loading...
Need help?
General
