Gerber Technology AccuPlot AP-300 User Manual

Hardware Summary 3-1
This chapter describes the basic physical attributes of the AccuJet and
AccuPlot 100/300 plotter families. Illustrations are included to help you
identify the components that are referenced in procedures. Before operating
any plotter or performing any maintenance, be sure you are familiar with its
hardware and safety features.
Hardware SummaryHardware Summary
All of the plotters discussed in this guide provide cable driven, X-Y plotting.
The beam moves on the Y-axis. All except the AP-100 and AP-300 models
allow single sheet offloading. Table 3-1 summarizes the physical
characteristics of each model.
Table 3-1 Plotter Physical Characteristics Summary
Model Pen Type Plot Width
Roll
Diameter
Single Sheet
Offloading
Carriage
Cabling Footprint
Reverse
Paper
Take-up
AP-100 disposable 1550 mm
(61.0 in.)
165 mm
(6.5 in.)
no whip 915 x 2090 mm
(36 x 83 in.)
no
AP-110 disposable 1550 mm
(61.0 in.)
241mm
(9.5 in.)
yes whip 915 x 2090 mm
(36 x 83 in.)
no
AP-300 disposable 2000 mm
(78.7 in.)
165 mm
(6.5 in.)
no whip 915 x 2667 mm
(36 x 105 in.)
no
AP-310 disposable
cartridge
2000 mm
(78.7 in.)
241mm
(9.5 in.)
yes whipless 915 x 2667 mm
(36 x 105 in.)
no
AP-320 disposable
cartridge
2000 mm
(78.7 in.)
241mm
(9.5 in.)
yes whipless 915 x 2667 mm
(36 x 105 in.)
yes
AP-350 disposable
cartridge
2400 mm
(94.5 in.)
241mm
(9.5 in.)
yes whipless 915 x 3035 mm
(36 x 119.5 in.)
no
AP-360 disposable
cartridge
2400 mm
(94.5 in.)
241mm
(9.5 in.)
yes whipless 915 x 3035 mm
(36 x 119.5in.)
yes
AP-520 longlife
(refillable
reservoir)
2000 mm
(78.7 in.)
241mm
(9.5 in.)
yes whipless 915 x 2667 mm
(36 x 105 in.)
yes
Figure 3-1 illustrates major components of the AP-100/AP-300 series plotters.
Figure 3-2 illustrates major components of the AccuJet AJ-520 plotter.
Plotter Hardware ComponentsPlotter Hardware Components
33

Gerber Technology AccuPlot AP-300 Specifications

General

Brand	Gerber Technology
Model	AccuPlot AP-300
Category	Plotter
Language	English