Gerber Technology AccuPlot AP-300 User Manual

AccuPlot and AccuJet Maintenance
Loading Plotter Paper 5-3
Loading Plotter PaperLoading Plotter Paper
The plotters uses plain, standard weight (50 grams per square meter/35
pounds) writing bond paper rolls.
NOTE:NOTE: The width of the paper roll affects how easily the roll can be handled. To load a
wide roll may require two people.
You need the following tools to load a new roll of paper:
• A ¼ inch hex wrench.
• A roll of paper (unpacked from its carton).
• A utility knife.
• An empty cardboard tube to use as the take-up roll. This tube must be
the same length as the supply roll. If you are replacing an empty
supply roll, you can use that as the new take-up roll.
• Masking tape.
Loading paper requires that you load the new supply roll, load the new take-
up roll, and feed the paper through the paper path. Procedures for loading
paper on the AccuJet begin on page 5-4. Procedures for the AccuPlot 100/300
Series plotters begin on page 5-9.
Read all the steps in each procedure before beginning. Be sure you understand
the steps and that you have all the tools necessary to complete the job.
NOTE:NOTE: Loading paper requires that you reach across the plotting area. ALWAYS be sure
servos are disabled when working on or near the plotting area of any plotter.

Gerber Technology AccuPlot AP-300 Specifications

General

Brand	Gerber Technology
Model	AccuPlot AP-300
Category	Plotter
Language	English