Gerber Technology AccuPlot AP-300 User Manual

AccuPlot and AccuJet Maintenance
Plotter Pen Maintenance 5-17
TO CLEAN THE INKJET CARTRIDGE
WARNING: FAILURE TO DISABLE SERVO POWER BEFORE PUTTING YOUR HANDS IN
OR NEAR THE PLOTTING AREA CAN RESULT IN INJURY.
1. Open a sliding cover so that you can reach the carriage and remove
the assembly cover.
2. Grasp the inkjet cartridge at the top and gently pull it outward until
the cartridge disengages from the spring retainer.
3. Wipe the cartridge jets with a dry cloth or paper towel.
4. Angle the base of the cartridge into the cartridge holder. Gently push
the top of the cartridge (in the direction of the arrow on top of the
cartridge) until it snaps into place in an upright position.
TO REPLACE THE INKJET CARTRIDGE
WARNING: FAILURE TO DISABLE SERVO POWER BEFORE PUTTING YOUR HANDS IN
OR NEAR THE PLOTTING AREA CAN RESULT IN INJURY.
1. Open a sliding cover so that you can reach the carriage and remove
the assembly cover.
2. Grasp the old cartridge at the top and gently pull it outward until the
cartridge disengages from the spring retainer. Discard the old inkjet
cartridge.
3. Angle the base of the new cartridge into the cartridge holder. You may
have to reach under the head cover and raise the cartridge holder unit
slightly.
4. Gently push the top of the new cartridge (in the direction of the arrow
on top of the cartridge) until it snaps into place in an upright position.

Gerber Technology AccuPlot AP-300 Specifications

General

Brand	Gerber Technology
Model	AccuPlot AP-300
Category	Plotter
Language	English