Getinge Maquet SERVO-i Service Manual

Servo-i Ventilator System Disassembling and assembling
Revision 02 Service Manual 4 - 1
4
Only personnel trained and authorized
by Maquet shall be permitted to perform
installation, service or maintenance of
the Servo-i.
Make sure to prepare the Servo-i properly before
disassembling and assembling. Refer to section
'Hazard notices' in chapter 'Important'.
Any service or maintenance must be noted in a
log book.
Discard disposable, replaced and left-over parts
in accordance with appropriate industrial and
environmental standards.
After any installation, maintenance or service
intervention in the Servo-i, perform a 'Pre-use
check'. Refer to the 'Servo-i Ventilator System –
User's Manual' for details.
4. Disassembling and
assembling
General .............................................................. 4 - 2
Preparations ...................................................... 4 - 2
Handling PC boards .......................................... 4 - 2
Replacing PC boards ........................................ 4 - 2
Assembling guidelines ...................................... 4 - 2
Tightening torque ........................................... 4 - 2
Threadlocking adhesives ............................... 4 - 2
User Interface .................................................... 4 - 3
PC 1777 Panel ................................................ 4 - 4
Backlight inverter ........................................... 4 - 4
TFT Display ..................................................... 4 - 4
Backlight lamps .............................................. 4 - 5
Touch screen assembly ................................. 4 - 6
Patient Unit ........................................................ 4 - 8
Front cover ..................................................... 4 - 8
PC 1771, PC 1772 and PC 1784 ................... 4 - 9
AC/DC Converter ........................................... 4 - 9
Module unit including PC 1775 ...................... 4 - 10
PC 1778 DC/DC & Standard connectors ...... 4 - 11
Internal fan ...................................................... 4 - 11
PC 1789 Remote alarm connector ................ 4 - 12
PC 1770 Main back-plane ............................. 4 - 12
Inspiratory channel ......................................... 4 - 13
Safety valve membrane .................................. 4 - 13
PC 1780 Pneumatic back-plane .................... 4 - 13
Gas modules .................................................. 4 - 14
PC 1785 Expiratory channel connector ......... 4 - 15
Expiratory valve coil ....................................... 4 - 15
Expiratory cassette membrane ...................... 4 - 16
Fixed battery module ..................................... 4 - 18
Control cable ..................................................... 4 - 18

Getinge Maquet SERVO-i Specifications

General

Brand	Getinge
Model	Maquet SERVO-i
Category	Medical Equipment
Language	English