Servo-i Ventilator System Service procedures
Revision 02 Service Manual 5 - 1
5
Only personnel trained and authorized
by Maquet shall be permitted to perform
installation, service or maintenance of
the Servo-i.
Make sure to prepare the Servo-i properly before
disassembling and assembling. Refer to section
'Hazard notices' in chapter 'Important'.
Any service or maintenance must be noted in a
log book.
Discard disposable, replaced and left-over parts
in accordance with appropriate industrial and
environmental standards.
After any installation, maintenance or service
intervention in the Servo-i, perform a 'Pre-use
check'. Refer to the 'Servo-i Ventilator System –
User's Manual' for details.
5. Service procedures
Checking the Battery modules ......................... 5 - 2
Replacing the lithium batteries on
PC 1771 and PC 1772 ...................................... 5 - 3
Using the Menu and Biomed key...................... 5 - 4
Menu ............................................................... 5 - 4
Biomed ........................................................... 5 - 4
Software installation .......................................... 5 - 6
General ........................................................... 5 - 6
Software information ...................................... 5 - 6
Software installation procedure ..................... 5 - 6
Field Service System ......................................... 5 - 6
General ........................................................... 5 - 6
Field Service System functions ..................... 5 - 6
To Next Page
Loading...
Need help?
General
