Servo-i Ventilator System Introduction
Revision 02 Service Manual 2 - 1
2
2. Introduction
Main units .......................................................... 2 - 2
User Interface ................................................. 2 - 4
Patient Unit ..................................................... 2 - 6
Servo-i software structure................................. 2 - 9
General ........................................................... 2 - 9
Breathing ........................................................ 2 - 9
Monitoring ...................................................... 2 - 9
Panel ............................................................... 2 - 9
System ID ....................................................... 2 - 9
Only personnel trained and authorized
by Maquet shall be permitted to perform
installation, service or maintenance of
the Servo-i.
Make sure to prepare the Servo-i properly before
disassembling and assembling. Refer to section
'Hazard notices' in chapter 'Important'.
Any service or maintenance must be noted in a
log book.
Discard disposable, replaced and left-over parts
in accordance with appropriate industrial and
environmental standards.
After any installation, maintenance or service
intervention in the Servo-i, perform a 'Pre-use
check'. Refer to the 'Servo-i Ventilator System –
User's Manual' for details.
To Next Page
Loading...
Need help?
General
