Getinge Maquet SERVO-i Service Manual

Servo-i Ventilator System Important
1 - 4 Service Manual Revision 02
General
• Service documentation for the Servo-i Ventilator
System consists of:
– User's manual. The User's manual is an
indispensable complement to the Service
Manual for proper servicing.
– Service Manual
– Installation Instructions
– Spare Parts information.
– Documentation for all optional equipment
included in the Servo-i System is also available.
• The Servo-i Ventilator System is referred to as
the Servo-i troughout this manual.
• There are two serial number labels on the unit:
– One label is attached to the Patient Unit close
to the supply gas inlets. The serial number
stated on this label is the ID number of the
Patient Unit. The serial number is also stored in
the SW memory as the 'System ID'.
– One label is attached to the rear side of the
User Interface close to the On/Off switch. The
serial number stated on this label is the ID
number of the User Interface.
• System version number can be found in the
Status window on the User Interface. Make sure
that the version of the User's manual
corresponds to the System version.
Text inside a box is used to highlight important
information.
• In addition to the Important information given
here and in the related documents (e. g. in the
User's manual), always pay attention to
applicable local and national regulations.
• Responsibility for the safe functioning of the
equipment reverts to the owner or user in all
cases in which service or repair has been done
by a non-professional or by persons who are not
employed by or authorized by Maquet, and when
the equipment is used for other than its intended
purpose.
1
Hazard notices
• Before disassembling or assembling of the
Servo-i, make sure that the:
– On/Off switch is set to Off.
– Mains power cable is disconnected.
– Gas supply is disconnected (wall and/or
cylinder).
– Battery modules are disconnected.
– The Servo-i is cleaned according to
instructions in the User's manual, chapter
'Routine cleaning' and chapter 'Regular
maintenance', section 'Extended cleaning of
inspiratory channel'.
• With power supply connected to the Servo-i,
there are energized electrical components inside
the unit. All personnel must exercise extreme
caution if fault tracing or adjustments are
performed with power supply connected and
with user interface and patient unit covers
removed.
Symbols used in this manual
• ESD sensitive components. When
handling ESD-sensitive devices,
established procedures must be
observed to prevent damage.
• Special waste. Discard disposable,
replaced and left-over parts in
accordance with appropriate
industrial and environmental
standards.
• Recycling. Recycle if possible.
Recycling facilities may not be
available in all areas.
• Technical training. Refers to the
Technical training supplied by
Maquet.
• Service contract. Refers to the
Service contract supplied by
Maquet.
Important

Getinge Maquet SERVO-i Specifications

General

Brand	Getinge
Model	Maquet SERVO-i
Category	Medical Equipment
Language	English