GIRBAU EH090 User Manual

Programming a new wash program 42
Code 429159
Rev. 15/0717
7.3.10. Rotation speed
Optional programming
Programming this function is only possible if the parameter has been activated in CONFIGURATION and a
rotation value has been programmed.
Allows selecting a rotation speed in the wash cycle, among four pre-programmed speeds. These speeds are
modifiable in the CONFIGURATION menu.
Depending on the load, the drum rotation speed can vary +/- 5 rpm regarding the programmed speed.
Possible programming
Rotation speeds in rpm
HS-6013
EH030
HS-6017
EH040
HS-6023
EH055
HS-6024
EH060
HS-6032
EH080
HS-6040
EH090
HS-6057
EH130
HS-6110
EH225
Speed 1
WS1
23
23
22
22
21
19
18
17
Speed 2
WS2
30
30
29
27
26
26
24
22
Speed 3
WS3
37
37
36
36
36
33
30
27
Speed 4
<<< Option
programme
d by default
WS4
44
44
43
42
42
40
36
32
7.3.11. Rotation time
The rotation time starts when the programmed values for level, dosing and temperature have been reached.
Programmable time range: 0 – 99 minutes
Value programmed by default: 1min.
7.3.12. Gradual cooling
Function that allows gradually reducing the bath temperature by admitting cold water up to 45ºC / 113ºF.
The cooling is executed once the rotation time ends and before the bath is drained.
This function is only programmable if the temperature programmed in the phase is greater than 50ºC / 122ºF.
Possible programming:
No gradual cooling
<<< Option programmed by default
Yes, gradual cooling

GIRBAU EH090 Specifications

General

Brand	GIRBAU
Model	EH090
Category	Washer
Language	English