Programming a new wash program 45
Code 429159
Rev. 15/0717
7.3.17. Buzzer
This buzzer is programmable at the end of each phase.
By default, the buzzer lasts 2 seconds. This value can be modified in the corresponding section of the
CONFIGURATION menu.
BUZZER and PAUSE programming.
Optional programming
This function appears only if PROGRAMMABLE PAUSE in the CONFIGURATION menu is activated.
The programming of this parameter:
stops the wash program from advancing to the end of the phase
activates the buzzer for the seconds selected while configuring the parameters
keeps rotation programmed in the phase
does not allow door opening
To resume the wash programme, press the key on the multi-function keyboard.
Possible programming:
No buzzer
<<< Option programmed by default
Programme pause and buzzer during the specified time in CONFIGURATION menu.
7.3.18. End of phase or program
When the last operation of the phase has been programmed, a screen with two options appears:
Access to programming a new phase.
The acceptance of this option creates a new one.
The number of the phase appears in the upper, central box on the screen and the first operation of
the new phase appears in the central box.
End of program. The previous menu is directly accessed.
The microprocessor is ready again to receive new programming or modification orders.
By pressing the key several times, the top menus are accessed.
7.4. Manual program. Definition and use
The MANUAL PROGRAM allows the user to create a customised program of a single phase for immediate use.
This option is available on models with microprocessor Version 21D/21F or later.
Creating a MANUAL PROGRAM
Press MAN on the main menu.
Program the various options which will appear successively on the washer screen.
This process is similar to programming a program phase. See Section 7.3 PROGRAMMING A PROGRAM
PHASE.
When the last function of the MANUAL PROGRAM has been programmed, two options will appear on the
screen:
Do not run the MANUAL PROGRAM.
To Next Page
Loading...
Need help?
General
