System tools 58
Code 429159
Rev. 15/0717
10.2. Configuring operation and programming parameters
Below, the distinct parameters found in the CONFIGURATION menu are listed.
Shown at each parameter:
Identification of the parameter: description that appears on the screen.
Explanation of the parameter.
Configurable values or range.
Factory settings: the factory settings of the washing machine will depend on the purchase specifications.
Configuration by default: is the option programmed by default at the washing machine control. The values
configured by default will always appear when a GENERAL INITIALIZATION is executed or when a new
control board is installed onto the washing machine.
When the factory settings value and the default configuration value coincide, it is only indicated as the
factory value.
To provide better access the parameters are grouped in three submenus:
Modifiable values table. Section 10.2.1.
Advance programming options. Section 10.2.2.
Operation parameters. Section 10.2.3.
10.2.1. Operation parameters
LANGUAGE
Permits selecting the language of all the written messages.
Programmable values ..............
ESP (Spanish) | ENG (English) | FRA (French) | CAT (optional language)
Factory settings .........................
depending on specification
Value by default ........................
Permits modifying the contrast on the washing machine screen.
Programmable values ............
0 (less contrast) ... 9 (more contrast)
Factory settings .......................
Permits selecting the unit that the temperature values are displayed .
Programmable values ............
C (Centigrade degrees)| F (Fahrenheit degrees)
Factory settings .......................
depending on specification
Value by default ......................
BEEP WHEN PRESSING THE KEY
When pressing a key, the microprocessor emits an acoustic beep. This beep can be annulled.
Programmable values ..............
Factory settings .........................