SAFETY
08/2012 2
Intended use
The CS 60 is intended solely for stripping the insulation off single- and multi-strand conductors
(wires).
Very hard insulation damages the stripping blades and must not be processed.
Do not insert any solid metal components and articles liable to damage the blades and clamping
jaws.
Changes to the CS 60 are prohibited for safety reasons!
Observance of all information and compliance with the prescribed operating
conditions form part of intended use.
Hazard area
The CS 60 may be operated only with the waste tray in place and in fully intact condition, as it
simultaneously acts as a protective hood.
Switch the stripper off during breaks and when it is not in use.
Workplaces
The following locations are to be avoided for operating and storing the stripper:
damp or dusty locations,
locations exposed to great heat, direct sunlight or low temperatures (operating range: 10°C to
40°C).
Do not spill any liquids on the CS 60.
Do not subject the CS 60 to high vibration or impact.
Protective devices
The CS 60 is switched off by
the on/off switch (0 pressed, display off).
disconnecting the power connector.
disconnecting the waste tray (protective hood).
The waste tray (protective hood) is necessary for the user’s safety. Under no circumstances may it
be changed, removed or evaded by making modifications.
A sign on the base of the stripper alerts to existing danger.
To Next Page
Loading...
Need help?
General
