[page 50] | gpelectric.com
8. END OF LIFE - RECYCLING INFORMATION
1.
Remove the screws holding the outer case to the base plate. The
plastic handles can be removed from the outer case by pushing them
out from the inside.
2.
Remove the screws holding the copper connectors. These can be
recycled with metals (copper).
Product E.O.L (End of life) Information
This product required the extraction and use of natural resources. It may contain substances that could be harmful
to the environment or human health if improperly handled at the product’s end of life. In order to avoid release of
such substances into the environment and to reduce the use of natural resources, we encourage you to recycle the
Inverter/Charger in an appropriate way that will ensure most of the materials are reused or recycled appropriately.
DO NOT DISPOSE OF THIS PRODUCT WITH NORMAL GARBAGE.
The easiest way to recycle an Inverter/Charger is to take the unit to a local certied e-waste (electronics waste) recycling center.
Knowingforsureifyourappliancesarebeingrecycledproperlyistricky.Ifyour’eindoubtjustask.Recyclersthatarecertied
shouldgladlyshowyoutheircertication.Iftherecycleriscertied,chancesareveryhighthattheyarerecyclingresponsibly.
Tondyourlocale-wastecenterpleasecontactyourlocalmunicipality.Thefollowingwebsitealsohasinformationonlocal
recycling centes: www.earth911.com/recycling-center-search-guides
Ifyouhavenolocalcertiede-wasterecyclingcenter,theICSeriesInverter/Chargercanbedisassembledmanuallyand
recycled responsibly. A Phillips screwdriver is required to disassemble the Inverter/Charger. Note: The IC Series should only be
disassembled at the end of its service life. Go Power! provides no spare parts for the Inverter/Charger.
3. Remove the screws holding PCB #1.
Metal Recycling
ALU
Aluminum
Metal Recycling
Copper
PCB
Recycling
(small electronics)
Plastic handles
Metal case
PCB #1
Copper connectors
ABS
Acrylonitrile
Butadiene Styrene
9
www.earth911.com/recycling-center-search-guides
Local recycling centers can be found here: