Setup
16 332689D
18. When you see paint coming out of prime tube:
a. Point gun into waste pail.
b. Unlock gun trigger lock.
c. Pull and hold gun trigger.
d. Move Prime/Spray valve to SPRAY.
NOTE: Some fluids may prime faster if the Power
Switch is momentarily turned off so the pump can
slow and stop. Repeat several times if necessary.
19. Continue to trigger gun into waste pail until you see
only paint coming out of gun.
20. Release trigger. Engage trigger lock.
21. Transfer prime tube to paint pail and clip prime tube
to suction tube.
NOTE: Motor stopping indicates pump and hose are
primed with paint. If motor continues to run the sprayer
is not properly primed. To reprime, move Prime/Spray
valve to PRIME and repeat step 18.
Install Tip and Guard on Gun
1. Engage trigger lock.
2. Verify tip and guard parts are assembled in order
shown.
3. Screw tip and guard assembly on gun. Tighten
retaining nut.
retaining nut
black rubber gasket and
guard
tip
ti22117a
metal seat
Use tip to align seat
Tip must be pushed
all the way into guard
in guard
ti11569a
ti11570a
To Next Page
Loading...
Need help?
General
