www.modellmarkt24.ch; www.modellmarkt24.de
The receiver does not feature specic sockets for connecting the battery. We recommend that you connect the power
supply to the socket(s) close to the servos already connected to the receiver. If you wish to connect multiple separate
batteries, the batteries must be of the same nominal voltage and capacity. Never connect batteries of dierent type, or
packs of greatly diering states of charge, as this can cause eects similar to a short-circuit. If you encounter this problem,
we recommend the use of a voltage stabiliser unit (e.g. PRX-5A receiver power supply, Order No. 4136) between
the batteries and the receiver.
Telemetry (T/9 at GR-18)
The optional telemetry sensors are connected to the socket marked “T” (T/9)- Telemetry. In addition, the update is
performed on this socket (see point 5). At the GR-18, the socket can be used optionally for K9.
48
Power supply
PROGRAMMING THE GENERAL RECEIVER SETTINGS
The receiver can be programmed using a suitable HoTT transmitter or the SMART-BOX (Order No. 33700).
3.2 RECEIVER SET-UP MENU GR-24
The receiver set-up menu
appears in the “Telemetry” menu
under SETTINGS / DISPLAYS;
alternatively - if you are using a
SMARTBOX - under SETTING &
DATAVIEW. The method of
accessing this menu is
described in the operating
instructions supplied with your
transmitter or the Smart-Box.
RECEIVER SET-UP MENU GR-18
www.modellmarkt24.ch; www.modellmarkt24.de
To Next Page
Loading...
Need help?
General
