Floor Ceiling Air-Conditioning Unit
14
See Fig.7.1 for how to view the running status of the indoor unit.
Fig.7.1 Viewing of the Running Status of the Indoor Unit
7.2 Control Mode
7.2.1 Single Control
Select the expected indoor unit through the indoor unit code button and then the code on the
LCD will ash.
Set the running status of the indoor unit and send out control commands, including On/Off,
Mode, Fan, ▲ / ▼, and Shield etc. Without any change to the setting in 2.5 seconds, the control
commands will be sent out.
Fourteen seconds (thirty seconds for the duct type unit) later after the control command is sent
out, the set parameters of the indoor unit will be displayed.
To Next Page
Loading...
Need help?
General
