Gree EVO Series Unit Installation Guide

1
Unit Installation
1.Installation Guides
WARNING!
①
Installation should be performed by GREE appointed servicemen, or improper installation would lead to
unusual operation, water leakage, electric shock or re hazard.
②
The unit should be installed on the foundation which is capable of supporting the unit, or the unit would fall
off or even lead to personal injury.
③
All electric installation should be done by electrician in accordance with local laws and regulations, as
well as the User’s Manual and this Service Manual. Besides, the special power lines should be used, as any
improper line would lead to electric shock or re hazard.
④
All electric lines should be safe and secured reliably. Be sure the terminal board and electric lines will not
be affected by any external force, or it would lead to re hazard.
⑤
The electric lines should run properly to make the cover of the electric box secured tightly, or it would
cause the terminal board overheated or cause electric shock or re hazard.
⑥
Cut off the power supply before touching any electric element.
CAUTION!
①
The unit should be grounded properly and the ground line is not allowed to connect with the gas line,
water line, lightning rod or phone line.
②
The breaker should be installed, or it would lead to electric shock.
③
The drain pipe should be installed in accordance with the User’s Manual and this Service Manual to
ensure free drainage, and the drain pipe should be insulated against condensation. Once the drain pipe is
installed improperly, it would lead to water leak which then will damps the ceiling and furniture.
④
Do not place the unit where there is oil fog, like kitchen, or the plastic would be aged, broken off or the
polluted evaporator would lead to water leak and poor performance.
⑤
Do not place the unit where there is corrosive gas (like sulfur dioxide), or the corroded copper tubes or
welded joint would lead to refrigerant leakage.
⑥
Do not place the unit where there is inammable gas, carbon ber, inammable dust or volatile
combustible, as they would lead to re hazard.
SAFETY!
①
Always use safety outts at the construction site.
②
No smoking and no drunken operation are allowed at the construction site.
③
Wear no gloves and tighten the cuff when operating the machinery and electrical equipment. Do not
maintain it during operation.
④
Use the abrasive-disk cutter and stand at the side of the rotating abrasive disk.
⑤
Clean the opening when installing the riser pipe, and then cover it tightly. Do not throw down any material.
⑥
The use of the electric and gas welders should be approved rstly. Once used, a re distinguisher should
be prepared and a service man should be there always. There should be no inammable and explosive
substances around the welding site.
⑦
A platform should be set up when working high above the ground.
1.1 Installation Positions of the Mini Chiller
(1). Avoid direct sunshine.
(2). Monobloc unit must be installed on a rm and solid support.
(3). Ensure the hanger rod, ceiling and building structure have sufcient strength to support the weight of air
conditioner unit.
(4). Avoid placing the monobloc unit under window or between two constructions, hence to prevent normal
operating noise from entering the room.
(5). Air ow at inlet and outlet shall not be blocked.
(6). Install at a well-ventilated place, so that the machine can absorb and discharge sufcient air.
(7). Do not install at a place where ammable or explosive goods exist or a place subject to severe dust,

Gree EVO Series Specifications

General

Brand	Gree
Model	EVO Series
Category	Air Conditioner
Language	English