16
Technical Information
Service Manual
6. Function and Control
6.1 Remote Controller Introduction for YAU1FB
1. ON/OFF
Press this botton to turn on the unit. Press this botton again to turn
off the unit.
2. FAN
Press this botton can select fan speed, it can be selected circularly
as below:
Under dry mode, fan speed can't be adjusted.
3. / button
● Press " " or " " button once increase or decrease set
temperature 0.5
o
C.
● Holding " " or " " button, 2s later ser tempurature on remote
controller will change quickly. On relasing button after setting
is finished, temperature indicator on indoor unit will change
accordingly.
4. MODE
Press this button to select your required operation mode.
5.
button
Press this button can select up & down angle. Fan blow angle can
be selected circularly as below:
Buttons on remote controller
Note:
● This is a general use remote controller, it could be used for the air conditioners with multifunction; For some function, which the model
doesn't have, if press the corresponding button on the remote controller that the unit will keep the original running status.
● After putting through the power, the air conditioner will give out a sound. Operation indicator " " is ON (red indicator, the colour is
different for different models). After that, you can operate the air conditioner by using remote controller.
● Under on status, pressing the button on the remote controller, the signal icon " " on the display of remote controller will blink once
and the air conditioner will give out a “de” sound, which means the signal has been sent to the air conditioner.
To Next Page
Loading...
Need help?
General
