1.Plug in, press ON/OFF button,
and then air conditioner is turned
3.Press SWING button, the
louvers start to rotate
automatically and stop when
repressed.
4.Press FAN button, set fan speed.
5.Press TEMP. button, set
suitable SET TEMP.
2.Press MODE button, set
operation mode.
- 7 -
on.
COOL mode operation procedure
According to the differences between room temp. and set temp. and
the rate dropping of room temp., microcomputer can control output power
If room temp. is higher than set temp., the compressor starts running. If
room temp. is lower than set temp. but higher than the value which set
temp. subtracted 2℃the compressor keeps in fuzzy operation between
maximum power and minimum power according to the difference in
temperature. If room temp. is 2℃lower than set temp., compressor will
If fan speed is set at AUTO mode microcomputer can control fan speed
of the indoor fan
Set temp. should
stop cooling, and outdoor fan motor will stop after 30 seconds, indoor fan
motor will keep running at the set speed.
of the compressor, that is, the cooling capacity. running at the set speed.
motor according to the
output power of the compressor.
be in range of 16
℃ to 30℃.
To Next Page
Loading...
Need help?
General
