Wired Controler XK60
68
communication fault.
③
Suppose that the air conditioner is installed where likely to suffer
electromagnetic interference, the communication line of the wired
controller must be shielded twisted pair.
4.3 How to Install the Wired Controller
First of all, the selection and connecting method of the
communication line is shown as follows:
Select appropriate communication line of the wired controller: 2-core
signal line (wire size
≥
0.75mm
2
, length
<
30m, recommended length: 8m).
After the indoor unit is de-energized, fix the communication line on
the indoor terminal board by screws.
Then, the specific installation steps is shown in the Fig.28:
To Next Page
Need help?
General
