7
Electrical Requirements
pureWash Pro
X2
requires 120 Volt 60 Hz power on a 15 amp fuse or circuit breaker.
Water Requirements
• Water pressure of 40 to 75 psi is required for pureWash Pro
X2
to operate correctly
and safely.
• Water quality may affect the performance of your pureWash Pro
X2
. If you have
water quality concerns, such as high iron content, consult a water filtration expert.
• Some later model high-efficiency washing machines require water from both
the cold and hot water supplies even if a cold water cycle is selected. In this case
the To Washer and Household Use outlets can be connected to supply the hot
and cold water inlets on the washer, or a Y-valve can be used to connect both
the cold and hot water hoses from one of the pureWash Pro
X2
outlet hose to the
washing machine.
PRIOR TO INSTALLATION
1. Remove your pureWash Pro
X2
from its packaging and inspect for any
shipping damage.
2. Turn off the hot and cold water supplies/faucets to your washing machine.
3. Remove the cold water hose from the cold water faucet.
4. Set Flow Rate Dial for type of washer. (i.e. Standard, High Efficiency) by
turning the dial on the back of the unit to the correct setting.
5. Remove the Desiccant Dryer Cartridge (located on the left side of the unit)
and peel away the Moisture Blocking Tab. Replace the Cartridge when
finished.
INSTALLATION REQUIREMENTS
To Next Page
Loading...
Need help?
General