8
1. The pureWash Pro
X2
should be fastened to the wall, just above and behind your washing ma-
chine. It is recommended that one of the mounting holes on the pureWash Pro
X2
be mounted
to a wall stud, if possible. One set of mounting screws are included. If it is not possible to mount
the pureWash Pro
X2
to a wall stud, you should use the provided “molly” type expandable screw
anchors. For any other type of mounting scenarios (concrete block, etc.) please consult your
local hardware store for assistance.
2. Use the provided Mounting Template to place your Mounting Bracket onto the wall with the
tabs facing up and away from the wall, making sure it is level, mark the locations of the screw
holes. If necessary, pre-drill your holes and use the supplied Wall Anchors. Fasten the Mounting
Bracket to wall using the supplied screws.
3. Place your pureWash Pro
X2
against the wall and gently slide the unit down into the lock position
of the mounting bracket slots.
4. Connect the existing cold water hose from your washer to the “To Washing Machine” port on
your pureWash Pro
X2
. Check that the rubber washer in the hose is in place and properly tighten
the hose, but DO NOT overtighten. Use a wrench to hold the hose bib secure while tightening the
hose connection.
5. With the supplied hose and in-line ball valve, connect them to the “Cold Water In” port on the
pureWash Pro
X2
, then connect this hose to your Cold Water Supply Faucet. Make sure rubber
washers are in place and properly tighten, but DO NOT overtighten. Again, use a wrench to hold
the hose bib secure on the pureWash Pro
X2
while tightening.
Do not use flood-preventing hoses with auto shutoff devices. The devices can be tripped
during fill and prevent the machine from filling properly.
Be sure the cold water connection has a shut-off valve and that hose connections are tight.
CLOSE the shut-off valve at the end of each wash.
6. Plug the power adapter into the DC adapter plug-in on the right side of your pureWash Pro
X2
and then plug the adapter into a wall outlet.
7. Ensure all hoses are properly installed and tightened, and that the power supply has been
properly installed. SLOWLY turn the water supply back on and check for any leaks or drips. Gently
tighten fittings if leaks are apparent, but DO NOT overtighten.
Water supply faucets should be readily accessible to permit turning them off when pureWash Pro
X
is not
being used.
IMPORTANT: Turn off water supply at the faucet or in-line ball valve connected to the pureWash inlet
whenever pureWash Pro
X2
is not in use.
CAUTION: The hot water hose should not be disconnected from the washer. You can turn off the hot water
or leave it on, but the hose must be installed to the washing machine to prevent backflow of water out of
the washing machine during use.
INSTALLATION
To Next Page
Loading...
Need help?
General