1. Move washer to its nal location. Check that the water and drain lines are not
strained or pinched. Make sure that all four legs are rmly in contact with the
oor and that the washer rests solidly in position.
2. Using a carpenter’s level, check that the washer is level from side to side and
from front to back.
3. If the washer is not level, adjust the leveling legs. Turn the legs to the left to
extend (raise the washer) or to the right to retract (lower the washer).
Raise
Lower
STEP 7 - COMPLETE INSTALLATION
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or electrical shock.
1. Plug the washer into a grounded 3 prong outlet.
2. Check that water faucet(s) is turned on.
3. Dispose of/recycle all packaging materials.
4. Run a normal wash cycle using detergent to test and clean the washer. See the
“Washer Use” section.
21
ENGLISH
To Next Page
Loading...
Need help?
General