4
Lights, Aux1 and Aux2 Outputs
Standard Relay: Manual operation of all 3 relays is identical. Assuming that the relay is currently off,
simply press the appropriate button to turn on the relay. If the relay does not turn on, it probably is due to
the “interlock” feature (which was set up in the Configuration Menu) being activated that requires the filter
pump to be running and the valves to be in the pool-only position. This protects pumps and other equip-
ment from possible damage. If the controlled output is on, pressing the appropriate button again will turn
off the relay. Manual turn off is disabled if the “Freeze Protection” feature is enabled and the air tempera-
ture is less than the selected freeze temperature threshold.
Dimmer Relay: If Lights or an Aux output is configured as a dimmer, pressing the corresponding button
will generate a temporary display which shows the dimmer output level (Off - On 100%). Pushing the “+”
or “-” button changes the level in increments of 20%. When the desired output level is displayed, press the
corresponding button again to turn off the display and return to normal operation. When the Lights or Aux
output comes on again (either manually or automatically), the dimmer output level will be the same as the
last time that it was set.
Pool/Spa Valves
Pool-only or spa-only systems: The POOL/SPA button has no function.
Pool and Spa systems without spa spillover: In pool-only mode, the left LED next to the POOL/SPA
button is illuminated. Pressing the POOL/SPA button will switch the AQL-P-4 to spa-only operation
(right LED illuminated). Pressing the POOL/SPA button again will switch back to pool-only. Note that
the filter pump will turn off while the pool/spa valves are turning.
Pool and Spa systems with spa spillover: In pool-only mode, the left LED next to the POOL/SPA
button is illuminated. Pressing the POOL/SPA button will switch the AQL-P-4 to spa-only operation
(right LED illuminated). Pressing the POOL/SPA button again will switch to spa spillover operation (both
LED’s illuminated). Pressing the POOL/SPA button again will switch back to pool-only. Note that the
filter pump will turn off while the pool/spa valves are turning.
Service
The main unit keypad has a SERVICE key. This button is used primarily during servicing of the pool
equipment. If you want to completely disable the automatic operation and operate the system manually,
you can put the system into Service or Service-Timed mode by pressing the SERVICE button. Pressing
the SERVICE button once will switch the system into service mode which means that all automatic func-
tions are disabled, and the remote display/keypads are disabled (except for manual turn off for emergen-
cies). The red SERVICE LED will be illuminated and the Aqua Logic will remain in this mode of operation
until manually taken out of service mode.
Pressing the SERVICE button again will cause the Aqua Logic to switch to service-timed mode which is
very similar to service mode, except that the Aqua Logic will automatically return to normal operation after
3 hours. During service timed operation, the “Service” LED will flash and the time remaining will be
displayed on the remote display/keypad(s).
Pressing the SERVICE button again, will return the Aqua Logic to normal (automatic) operation. See
Troubleshooting/Diagnostic Information (page 30) for more information about the service modes.
To Next Page
Loading...
Need help?
General
