Inspect Field Wiring Panel, ensuring all plugs are
securely fastened (pg. 5). IF correct, proceed to
step 1D.
Test Fuses
Verify that FC1 & FC2 fuses aren’t blown. Replace
all blown fuses & go to Page 29. IF correct, go to
step 1E.
Inspect connections
IF voltage is present, go to step 1B. IF voltage is
incorrect, correct source power.
Check Incoming Power
Verify selector plug matches incoming line power.
IF it does not, power OFF & correct. IF OK, go to 1C.
Voltage selector plug
1. Heater Not Powering Up
Step 1B
31
Step 1A
Step 1C
Step 1D
To Next Page
Loading...
Need help?
General
