Hikmicro THUNDER Series User Manual

Thermal Image Scope User Manual
7
Figure 2-6 Change Eyepiece
2.5 Power On/Off
Power On
When the battery is sufficiently charged, hold for about 2 seconds to power on the device.
Power Off
When the device is turned on, hold for about 2 seconds to power off the device.
Note
● Power-off countdown will appear when you power off the device. You can press any key to
interrupt the countdown and cancel the power-off.
● Automatic low battery power-off cannot be canceled.
Auto Power Off
Set the auto power off time for your device, and then the device will automatically shut down as
the set time.
Steps
1. Hold to go to the menu.
2. Press or to select , and press to select the auto power off time as
required.
3. Hold to save and exit.
Note
● See the battery icon for the battery status. means the battery is fully charged, and
means that the battery is low.
● When the low power note shows, charge the battery.
● The auto power off countdown will start again when the device exits standby mode, or the
device is restarted.

Hikmicro THUNDER Series Specifications

General

Brand	Hikmicro
Model	THUNDER Series
Category	Thermal cameras
Language	English