Hikmicro THUNDER Series User Manual

Thermal Image Scope User Manual
17
Chapter 4 Zeroing
4.1 Select Reticle Group
If different users use the same device, the users can configure and save the reticle settings in their
respective reticle group.
Steps
1. In the view mode, hold to show the menu.
2. Select .
3. Press to switch the reticle group.
4. Hold to save and exit.
Result
The right top of the image displays the reticle information. For example, A2-100 m means you are
using the No. 2 reticle in reticle group A, and the set range is 100 m.
Figure 4-1 Using Reticle
Note
There are 5 reticle groups in total, and you can configure 5 reticles in each reticle group.
4.2 Correct Reticle
Enable the reticle to view the position of the target. The functions such as freeze and zoom help to
adjust the reticle more accurately.
Steps
1. In the view mode, hold to show the menu.
2. Press or to select , and press to enter the reticle setting interface. A reticle
shows in the center of the view.

Hikmicro THUNDER Series Specifications

General

Brand	Hikmicro
Model	THUNDER Series
Category	Thermal cameras
Language	English