Hikmicro THUNDER Series User Manual

Thermal Image Scope User Manual
18
3. Press to select a reticle No. You can select OFF to disable the reticle.
4. Press or to select Distance. Press to switch the digit, and press or to
change the number. Press to confirm.
5. Press or to select Type, and press to switch the reticle type. 10 types of reticles
can be selected.
6. (Optional) Press or to select Freeze. Press to enable or disable the function.
Note

When you switch the reticle No., a prompt will appear on the interface. Select OK to save the
parameters for the current reticle.

When enabling the freeze function in reticle, you can adjust the position of the cursor on a
frozen image. This function can prevent image flutter.
7. (Optional) Press or to select Zoom. Press to switch the zoom ratio.
8. Press or to select the coordinates, and press to switch the X and Y axis. If you
select X, the reticle moves left and right; if you select Y, the reticle moves up and down.
9. Press , , , and to move the reticle until it reaches the target position. The
coordinates show the current position of the reticle, and the small reticle indicates the initial
position of the reticle.
10. Hold to exit the interface according to the prompt.
– OK: Save the parameter and exit.
– CANCEL: Exit but not save the parameters.

Hikmicro THUNDER Series Specifications

General

Brand	Hikmicro
Model	THUNDER Series
Category	Thermal cameras
Language	English