User Manual of 9600/8600/7700/7600 Series NVR
160
Note: At least one available physical disk should exist for rebuilding the array.
Figure 10. 21 Rebuild Array Interface
4. Select the available physical disk and click OK button to confirm to rebuild the array.
5. The “Do not unplug the physical disk when it is under rebuilding” message box pops up. Click OK button to
start rebuilding.
6. You can enter the Array Settings interface and Virtual Disk interface to view the rebuilding status.
7. After rebuilding successfully, the array and virtual disk will restore to Functional.
Note: It is recommended to enable the Auto-rebuild function and set the hot spare disk for automatically rebuilding
the array.
To Next Page
Loading...
Need help?
General