User Manual of 5-inch Smart Speed Dome
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Chapter 2 Getting Started
2.1 Power-up Action
After the power is applied, the speed dome will perform a series of self-test actions. It performs lens
actions firstly, then the panning movement and the tilting movement at last. After the power-up
self-test actions, the system information will be displayed for 2 minutes on the live view screen as
shown below.
TYPE DS- 2XX1-XXX
SN 000000000
ADDRESS 0
COM FORMAT 2400,8,1
PROTOCOL ADAPTIVE
VERSION 0. 00
BUILD DATE 12 05 17
Figure 2-1 System Information
Table 2-1 Descriptions of the System Information
The model of the speed dome.
The serial number of the speed dome.
The default communication address of the speed dome.
The communication settings of the speed dome. Baudrate (4 digits),
data bit (1 digit) and stop bit (1 digit).
It is for communicating with other devices.
The version of the firmware.
The date when the program of the software is compiled.
Note: Please make sure that the baudrate, protocol and address have been configured to the same
as those of the speed dome in the remote configuration interface of the control device. Please refer
to Table 2.1 for details of the configuration.
2.2 Basic Operations
You can operate the speed dome using a control device. The control devices include the control
To Next Page
Loading...
Need help?
General
