User Manual of 5-inch Smart Speed Dome
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
You can select the corresponding preset number from the drop-down preset list in the control
panel of the DVR through a web browser, and click the arrow to call the related patrol. E.g. call
preset 35 to call patrol 1. Please refer to Section 2.3 to find the corresponding preset number for
each patrol.
Task 4: Configuring the shortcut patrol.
Calling the system-defined preset 46 can enable the shortcut patrol. The patrol starts from the
number 1 preset to number 32 preset by default.
You can set the duration time in a preset scene by adjusting PATROL-D TIME. The value can be 5,
10, 20, 30 and 60s.
3.4.4 Configuring Patterns
Purpose:
A pattern is a memorized, repeatable series of panning, tilting, zooming and preset movements that
can be recalled by a command or automatically performed by a configured function (alarm, park,
time task, and power-up).
Figure 3-18 Pattern Configuration Menu
Task 1: Set a pattern.
Steps:
1. Move the cursor to enter the PATTERNS submenu:
MAIN MENUS > DOME SETTINGS > PATTERNS
2. Choose the pattern number.
Steps:
(1) Move the cursor to PATTERN NUM and click IRIS+ to enter edit mode.
(2) Click the up and down direction buttons to select the number of the pattern which is to be
configured.
(3) Click IRIS+ again to confirm.
Note: You can configure up to 4 patterns.
3. Edit the pattern.
Steps:
(1) Move the cursor to EDIT PATTERN and click IRIS+ to enter edit mode.
To Next Page
Loading...
Need help?
General
